Thursday, 12 July 2012

Growing Chiles - Tips For PH and PPM


Growing chiles hydroponically is very fun and rewarding. I have done so for several years, to give you some recommended nutrient strength and PH I have put together this brief article.

Ok to start of I can recommend a PH from 5.8-6.3 as ideal. In fact best is to get it down to just under 6 and let it go somewhat over 6 before you correct (or replace nutrient). A standard EC would be from 1.3-1.8, depending on plant size, kind, specie or pod size.

Your JalapeƱos are supposed to be a fast growing variety with a rather big pod size and for them I'd say to go up until 1.8. Convert to your ppm by the appropriate factor in case. More important is to choose the right nutrient that focuses on Potassium as for tomatoes or night shade (no vegetative or lettuce formula). Start your seedlings with 0.5-0.8 mS/cm and increase gradually. Any product that comes close enough to:

N=160-180 ppm 
P= 30-50 ppm 
K= 250-280 ppm 
Ca= 150-180ppm 
Mg= 35-50 ppm 
S= 50-90 ppm 
+All needed trace elements

-is suited for hot peppers and as well as for your JalapeƱos. In case you are not familiar with elemental ppm, ask the manufacturer or local store.

Anyways, make the total of the ppm in the formula; add 10% and you'll see that you stay clearly under 1000 ppm. No need to feed any higher concentration, just trust me.
As for replacing or topping off, there is in fact no such thing as a standard procedure. All depend on evaporation/consumption, PH and EC fluctuations.
You either have a smaller reservoir and replace the whole content every week, or have a larger and top off and/or replace only after about 2 weeks (+). The more PH and EC fluctuations you have got, (which is most likely to happen with a smaller reservoir), the more you have to correct PH and EC. Much of the PH stability will depend on your tap water quality anyway. If the PH is too high (after adding the nutrients) in the first place, think of using different water.
Work out your own nutrient strategy according to your water quality (PH), reservoirs size and consumption/evaporation in ways you have don’t have too much fluctuation, but note you do not need to step in too much either.

Believe it or not follow this simple guide and you will be enjoying the fruits of your labor in a few months time.